Corvette V8-6.0L VIN U (2005)
8. Disconnect the rear purge pipe (1) at the chassis purge pipe (3).
9. Cap the rear purge pipe.
10. Remove the chassis purge pipe (4) rear underbody retainer nuts (3).
11. Remove the chassis purge pipe (4) from the rear underbody retainers (2).
12. Disconnect the chassis purge pipe (4) from the side underbody retainers (6).
13. Remove the chassis purge pipe.
INSTALLATION PROCEDURE
1. Install the chassis purge pipe (4) into the side underbody retainers (6).
CAUTION: Refer to Fuel and EVAP Pipe Caution in Service Precautions.
IMPORTANT:
-
Follow the same routing as the original pipe.
-
Secure the pipe in order to prevent chafing.
-
Do not kink or bend the pipe.
2. Install the chassis purge pipe (4) into the rear underbody retainers (2).
3. Install the underbody retainers (2) on the mounting studs (1).
4. Install the chassis purge pipe (4) underbody retainer nuts (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the EVAP pipe retainer bracket nuts to 6 N.m (53 lb in).
