Corvette V8-6.0L VIN U (2005)
2. Install the driveline tunnel closeout panel.
3. Install the exhaust intermediate pipe.
4. Lower the vehicle.
5. Remove the cap from the engine compartment fuel feed pipe.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Connect the chassis fuel and EVAP pipe retainer (1) at the upper front of dash mounting stud (3).
Tighten the fuel and EVAP pipe retainer nut to 6 N.m (53 lb in).
7. Connect the fuel feed hose (2) to the chassis fuel feed pipe (3).
8. Tighten the fuel filler cap.
9. Connect the negative battery cable.
10. Perform the following procedure in order to inspect for leaks:
1. Turn the ignition switch ON for 2 seconds.
2. Turn the ignition switch OFF for 10 seconds.
3. Turn the ignition switch ON.
4. Inspect for fuel leaks.
11. Install the left fuel rail cover.
12. Program the transmitters. Refer to Transmitter Programming (Domestic) Transmitter Programming (Export - Including Canada) in Keyless Entry.
