Corvette V8-6.0L VIN U (2005)
10. Carefully remove the fuel pump module from the fuel tank, with the jet lines connected. Take care not to damage the fuel sender float arm.
11. Disconnect the jet line quick-connect connectors from the fuel pump module, noting the location of the lines for installation.
12. Remove the fuel pump module O-ring from the fuel tank opening.
13. Remove the jet line insert through the crossover tube to fuel tank opening.
INSTALLATION PROCEDURE
1. Inspect the jet line insert for damage and replace if necessary.
2. Install the jet line insert through the crossover tube to fuel tank opening.
3. Install a new fuel pump module O-ring to the fuel tank opening.
4. Pull the jet line quick-connectors up through the pump module opening, connecting the lines to the pump module as previously noted.
IMPORTANT: Pull on each connector to ensure that the connectors are properly latched.
5. Install the pump module into the fuel tank, taking care not to damage the float arm.
6. Compress and align the fuel pump module, while installing the lock ring.
7. Using the J39765-A, fully lock the fuel pump module lock ring in place.
8. Using a DMM, verify the full and empty readings resistance reading of the fuel pump module. Turn the fuel tank upside down to achieve the full