Corvette V8-6.0L VIN U (2005)
5. Disconnect the throttle position (TP) sensor electrical connector.
6. Disconnect the crankcase ventilation hose from the throttle body.
7. Remove the throttle body attaching bolts.
8. Remove the throttle body and the gasket.
IMPORTANT: Do not reuse the throttle body gasket. Install a new gasket during assembly.
9. Discard the throttle body gasket.
10. Inspect the crankcase ventilation hose and the tube. Replace any damaged components.
INSTALLATION PROCEDURE
1. Install a new throttle body gasket.
2. Install the throttle body assembly.
NOTE: Refer to the Fastener Notice in Service Precautions.
IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
3. Install the throttle body attaching bolts.
Tighten the throttle body bolts to 10 N.m (89 lb in).