Corvette V8-6.0L VIN U (2005)
Body Control Module: Scan Tool Testing and Procedures
Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Accy. Indicator Command: The scan tool displays the status of the accessory indicator.
Accy. Relay Command: The scan tool displays the status of the accessory output.
Auxiliary Power: The scan tool displays the status of the auxiliary power relay.
Battery Voltage Signal: The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition
feed input.
Brake Apply Sensor Reference Signal: The scan tool displays the voltage read by the brake apply sensor.
Current Power Mode: The scan tool displays the current power mode.
Idle Boost Level: The scan tool displays the level of the idle boost.
Ignition Cycle Counter: The scan tool displays the ignition cycle counter.
Ignition Mode Switch: The scan tool displays the voltage and the state read by the module from the ignition mode switch.
Ign. Mode Sw. Dimming Command: The scan tool displays the status of the ignition mode switch dimming.
Inadvertent Power Cmd.: The scan tool indicates the status of the inadvertent power command.
Inadvertent Power Signal: The scan tool displays the status of the inadvertent power signal.
Key in Cylinder Switch: The scan tool displays if the key is in the trunk cylinder switch.
Off Indicator Command: The scan tool displays the status of the off indicator.
Run/Crank Relay Command: The scan tool displays if the run/crank relay is controlled or not by the module.
Start Indicator Command: The scan tool displays the status of the start indicator.
