Corvette V8-6.0L VIN U (2005)
8. Using a wrench on the transmission manual shaft wrench flats (in order to keep the shaft from turning), remove the range selector (shift) lever
retaining nut.
9. Remove the range selector (shift) lever.
10. Check that the transmission is still in NEUTRAL.
11. Remove the park/neutral position switch mounting bolts.
12. Slide the switch off of the manual shaft.
Installation Procedure
1. Install the J 41364-A to the park/neutral position switch.
1. Align the two lower slots on the switch (2) with the two lower tabs on the J 41364-A.
2. Rotate the tool until the upper pin on the tool is lined up with the slot on the top of the switch (1).
2. Check that the transmission is still in NEUTRAL.
3. Important: Do not remove the J 41364-A from the park/neutral position switch until instructed.
Install the park/neutral position switch to the transmission manual shaft.
1. Align the flats in the switch hub with the flats on the manual shaft.
2. Slide the switch onto the transmission manual shaft until the switch mounting bracket contacts the mounting bosses on the transmission case.
4. Notice: Install the park/neutral position switch mounting bolts.
Tighten the park/neutral position switch mounting bolts to 27 Nm (20 ft. lbs.).
5. Remove the J 41364-A from the switch.
