Corvette V8-6.0L VIN U (2005)
Fuel Level Sensor: Service and Repair
Fuel Sender Assembly Replacement (Right)
FUEL SENDER ASSEMBLY REPLACEMENT (RIGHT)
TOOLS REQUIRED
J39765-A Fuel Sender Lock Ring Tool
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the right fuel tank.
3. Place the fuel tank on a suitable work surface.
4. Disconnect the evaporative emission (EVAP) purge line (4) from the fuel pump module.
5. Disconnect the fuel pump module harness connector (5).
6. Disconnect the fuel tank pressure (FTP) sensor harness connector (1).
7. If replacing the fuel pump module, remove the FTP sensor (2).
8. Disconnect the jet line insert connector from the crossover tube to fuel tank opening.
9. Using the J39765-A, remove the fuel pump module locking ring.
IMPORTANT: The fuel pump module is spring loaded and will spring upward when the locking ring is removed.
