Corvette V8-6.0L VIN U (2005)
1. Position the starter motor to the block.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the starter motor bolts.
Tighten the starter motor bolts to 50 N.m (37 lb ft).
3. Install the starter motor S terminal washer and purple lead wire (1).
IMPORTANT: Orient the purple lead wire to the 10 o'clock position when installing.
4. Install the S terminal nut (2).
Tighten the S terminal nut to 4 N.m (35 lb in).
IMPORTANT: Orient gray and rust harness leads to the 6 o'clock and 7 o'clock position.
5. Install the gray and rust harness leads to the solenoid.
6. Install the positive battery cable terminal to the solenoid.
7. Install the positive battery cable nut.
Tighten the positive battery cable nut to 8 N.m (71 lb in).
8. Install the catalytic converter.
9. Connect the negative battery cable.
