Corvette V8-6.0L VIN U (2005)
Installation Procedure
1. Raise the crossmember to the vehicle.
1. Align the crossmember dowel pins to the frame rails.
2. Align the engine mount studs.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install new crossmember mounting nuts.
Tighten the new crossmember mounting nuts to 110 N.m (81 lb ft).
3. Install the engine mount lower nuts.
*
Engine Mount Replacement - Left in Engine Mechanical - 6.0 L
*
Engine Mount Replacement - Right in Engine Mechanical - 6.0 L
4. Fasten the wheel speed sensor wiring harness retaining clips to the crossmember.
5. Fasten the brake pipe to the retaining clips on the crossmember.
6. Connect the electrical harness to the clips on the crossmember.
7. Connect the brake pipe to the clips on the crossmember.