Corvette V8-6.0L VIN U (2005)
1. Notice: Refer to Fastener Notice in Service Precautions.
Using the J 41099, install the reverse lockout solenoid.
^
Tighten the reverse lockout solenoid to 40 Nm (30 ft. lbs.).
2. Connect the reverse lockout solenoid electrical connector.
3. Slowly raise the rear suspension crossmember to seat to the vehicle frame rails.
4. Using ONLY HAND TOOLS, install NEW rear suspension crossmember mounting nuts.
^
Tighten the rear suspension crossmember mounting nuts to 110 Nm (81 ft. lbs.).
5. Remove the transmission jack from the rear suspension crossmember.
6. Connect the wiring harness and brake pipe clip retainers to the rear suspension crossmember.
7. Install the rear transverse spring.
8. Remove the tie-off retainers from the muffler assemblies.
9. Install the intermediate exhaust pipe to muffler bolts.
^
Tighten the intermediate exhaust pipe to muffler bolts to 50 Nm (37 ft. lbs.).
10. Install the rear tire and wheel assemblies.
11. Lower the vehicle.
12. Connect the negative battery cable.
^
Tighten the negative battery cable bolt to 15 Nm (11 ft. lbs.).
13. Program the transmitters.
