Corvette V8-6.0L VIN U (2005)
^
Tighten the rear exhaust hanger mounting bolts to 50 Nm (37 ft. lbs.).
6. Install the transmission oil cooler pipes into position.
7. Install the transmission oil cooler pipe front and rear retaining clamps and bolts.
^
Tighten the transmission oil cooler pipe front and rear retaining clamp bolts 12 Nm (106 inch lbs.).
8. Install the transmission oil cooler pipe middle clip.
9. Install the transmission oil cooler pipe rear clip.
10. Remove the caps from the transmission oil cooler pipes and remove the plugs from the fittings on the transmission.
11. ALIGN and HAND-START, then tighten ONLY by hand to seat the transmission oil cooler pipe fittings to the transmission fittings.
^
Tighten the transmission oil cooler fittings to 40 Nm (30 ft. lbs.).
12. Position the chainfall, or equivalent lifting device, in a way which will protect the transmission oil cooler rear pipes and the rear exhaust hangers
located on the driveline support assembly.
