Corvette V8-6.0L VIN U (2005)
22. Rotate the inner race 90 degrees to the centerline of the cage.
23. Align the lands of the inner race with the windows of the cage.
24. Insert an inner race land into a cage window.
25. Pivot the inner race down and remove it from the cage.
26. Clean the following thoroughly with clean solvent:
^
The inner race
^
The outer race
^
The cage
^
The balls
^
The axle shaft exposed end.
Important: All traces of old grease and any contaminates must be removed.
27. Thoroughly air dry all the parts.
Installation Procedure
Notice: Wheel drive shaft boots, seals and clamps should be protected from sharp objects any time service is performed on or near the wheel drive
shaft(s). Damage to the boot(s), the seal(s) or the clamp(s) may cause lubricant to leak from the joint and lead to increased noise and possible failure
of the wheel drive shaft.
1. Position the cage so the larger radius corners of the cage windows are up.
2. Position the inner race 90 degrees to the centerline of the cage.
3. Begin to insert the inner race up through the bottom of the cage.
4. Align a land of the inner race to a window of the cage.
5. Insert the inner race land into the cage window.
6. Rotate the remainder of the inner race into the cage.
7. Rotate the inner race within the cage so that the grooved surface of the inner race is facing up.
8. Align the inner race ball tracks with the cage windows.
9. Wrap a shop towel around the joint outer race splined shaft.
10. Place the outer race vertically in a bench vise.
11. Position the cage and inner race 90 degrees to the centerline of the outer race.
12. Align two cage windows at 0 and 180 degrees. Rotate the inner race and cage assembly in the vertical plane.
13. Align the two windows at 0 and 180 degrees with two of the outer race lands.
14. Insert the cage and inner race into the outer race.
