Corvette V8-6.0L VIN U (2005)
Shift Solenoid: Service and Repair
Gear Select/Skip Shift Solenoid Replacement
Gear Select/Skip Shift Solenoid Replacement
^
Tools Required
-
J 41099 Gear Select/Reverse Lockout Solenoid Socket
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the gear select solenoid electrical connector.
3. Using the J 41099, remove the gear select solenoid.
Installation Procedure
1. Notice: Refer to Fastener Notice in Service Precautions.
Using the J 41099, install the gear select (skip shift) solenoid.
^
Tighten the gear select solenoid to 40 Nm (30 ft. lbs.).
2. Connect the gear select solenoid electrical connector.