chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Transmission Fluid Cooler Connector Replacement (Lower Radiator)|Page 6395 > < Transmission Fluid Cooler Connector Replacement (Lower Radiator)|Page 6393
Page 20
background image

^

Tighten the bolt to 12 Nm (9 ft. lbs.).

5. Check the transmission fluid level, add fluid if necessary. 
6. Remove the drain pan.
7. Install the driveline tunnel closeout panel. 
8. Lower the vehicle. Refer to Vehicle Lifting.

Transmission Fluid Cooler Lower Pipe Replacement - Intermediate to Differential Cooler

 

Transmission Fluid Cooler Lower Pipe Replacement - Intermediate to Differential Cooler 

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Install a drain pan under the vehicle.

3. Important:  Cap or plug the open transmission fluid cooler pipes immediately to prevent system contamination.

Disconnect the intermediate transmission fluid cooler lower pipe from the rear transmission lower pipe. 

4. Remove the transmission cooler pipe clip.
5. Remove the rear transmission lower pipe from the differential oil cooler. 
6. Remove the rear transmission fluid cooler lower pipe from the vehicle.

Installation Procedure

1. Install the rear transmission fluid cooler lower pipe to the vehicle.

Transmission Fluid Cooler Connector Replacement (Lower Radiator)|Page 6395 > < Transmission Fluid Cooler Connector Replacement (Lower Radiator)|Page 6393