Corvette V8-6.2L (2008)
16. Remove pieces of the bumper bar which are left attached to the rail ends.
17. Straighten and deburr the rail ends. Keep the perimeter and shape of the rail end as original as possible.
Installation Procedure
Important: Due to welding accessibility, it may be necessary to weld the triangle brackets (1) to the bumper bar prior to installation of
the bumper bar.
1. Dry fit the bumper bar for proper fit and alignment before welding.
Important: Use a stainless steel brush to remove the oxide layer prior to welding.
2. Clean and prepare all of the welded mating surfaces.
3. Install the rear bumper bar.
4. Position the bumper bar to the vehicle using 3-dimensional measuring equipment.
