Corvette V8-6.2L (2008)
7. Using a P-MIG welder, weld (1) the bumper bar to the outer and inner of the rear frame rails duplicating the factory welds.
Important: DO NOT top coat the bonding surface of the battery tray. Use primer only on bonding surfaces. Refer to adhesive
manufacturer's recommendations.
8. Clean and prepare all bonding mating surfaces according to adhesive manufacturer's recommendations.
9. Apply a consistent bead of structural adhesive to the battery tray to bond to the rear compartment panel. Refer to Sheet Molded Compound (SMC)
Panel Bonding () .
10. install the battery tray (1).
11. Clamp or mechanically fasten the battery tray into place as necessary.
