Corvette V8-6.2L (2008)
Front Door Striker: By Symptom
Technical Service Bulletin # 09-08-64-027
Date: 090709
Body - Snapping/Popping Noise Door Or Lock Pillar
TECHNICAL
Bulletin No.: 09-08-64-027
Date: July 09, 2009
Subject: Snapping or Popping Noise from Rear of Door or Lock Pillar Area (Replace Door Latch Striker)
Models:
2008-2010 Chevrolet Corvette
Condition
Some customers may comment about a snapping or popping noise coming from the rear of the door or lock pillar area. This condition is most noticeable
when the vehicle is being driven over rough and uneven road surfaces. It may also be noticed during slow speed conditions, such as parking lots and
driveway approaches.
Cause
This condition may be caused by excessive clearance in the front side door lock striker. The door lock striker is located on the door and the latch is on
the body.
Correction
Use the following steps to diagnose and repair the condition.
Diagnosis
1. Open the door on the affected side of the vehicle and locate the door lock striker mounted on the door.
2. Apply hand pressure to the striker in an up/down and side to side motion and listen for a clicking type sound.
3. If the lock striker makes a clicking noise, use the steps below to replace the striker. If no noise is heard, diagnose the condition using standard
procedures found in SI.
Repair Procedure
1. Remove the front side door trim panel on the affected side. Refer to Front Side Door Trim Panel Replacement in SI.
2. Remove the large water deflector (1) for inside access to the rear of the door.
3. Mark the striker location on the outer door edge.
