Corvette V8-6.2L (2008)
Front Door Weatherstrip: Service and Repair
Weatherstrip Side Retainer Replacement (Hardtop)
Weatherstrip Side Retainer Replacement (Hardtop)
Removal Procedure
1. Remove the weatherstrip.
2. Remove the weatherstrip retainer.
3. Remove the blow out clip, if reusing the clip.
4. Clean the mounting surfaces.
Installation Procedure
1. Apply a bead of sealer (2) to the blow out clip.
2. Peel the protective cover from the foam tape on the back of the retainer.
3. Position the clip to the back of the retainer.
4. Apply a bead of sealer (1) to the area where the clip will contact the reveal molding.
5. Apply, outboard of the two screw holes where the retainer bends, a continuous bead of sealer (5) to the applique and the reveal molding.
6. Replace any stripped, broken or improperly seated screws.
7. Install the windshield weatherstrip side retainer.
Notice: Refer to Fastener Notice .
