Corvette V8-6.2L (2008)
Note
The anti-glare screen strings are routed through a D-ring that is riveted to the #5 bow, on each side. It is NOT necessary to remove these
rivets/D-rings for headliner replacement. After removal of the retaining screws, the end eyelet of each anti-glare string must be fed back through
the D-rings. This can be accomplished by slightly opening up the diameter of the D-ring to allow the eyelet to pass through.
7. Remove the screw (1) from the right and left sides of the string holding the anti-glare screen (shown in red above) to the rear side rail. Fold the
anti-glare screen over the top of the number 5 bow.
8. Disconnect the folding top #5 bow link arm pins/spring clips and set the arms (1) aside.