Corvette V8-6.2L (2008)
Some customers may comment on small holes in the rear corners of the headliner.
Cause #1
This condition may be caused by a sharp edge on the outer headliner trim, causing the wear.
Cause #2
Note
The forward location on each side (1) uses a longer 24.5mm (0.965 in) pin and the rear locations (2) use a 20mm (0.787 in) pin. Also, the pin retainers
were changed from a square to a round push nut in mid-model year 2007.
This condition may be caused by any of the four pins and retainers (two per side), which face inward on the folding top. The left side locations are shown
in the illustration above.
Or by the sharp edges (2) from the first design folding top link mechanism, shown above, which may be wearing small holes in the rear corners of the
headliner when it is stowed.
