Corvette V8-6.2L (2008)
2. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions, using the Legacy
Pass-Thru method. Select "VTD Vehicle Theft Deterrent Learn" under Component Replacement. Ensure that "Prepare RCDLR for key fob
programming" is chosen.
3. At this point the scan tool must remain connected for the duration of the 10 minute relearn procedure.
4. When complete, select CONTINUE on the Tech 2, then exit out to the Vehicle Control Systems menu.
5. Use the scan tool to access the following:
*
Vehicle Control Systems
*
Computer/Integrating Systems
*
Module Setup
*
Remote Control Door Lock Receiver
*
Program Key Fobs
6. Select INVALIDATE ALL FOBS and press the PROGRAM button.
7. The DIC will display a message: READY FOR FOB 1
8. Place the replacement key fob in the glove box pocket with the buttons facing right. A beep will occur indicating programming completion. The
DIC will display a message: READY FOR FOB 2
9. If programming additional key fobs, repeat step 12, or press the OFF/ACC portion of the ignition switch to exit programming.
Important: Failure to press the UNLOCK button of each key fob will result in that fob being inoperative. Pressing the UNLOCK button
finishes the programming sequence and is require to ensure transmitter operation.
10. Press the UNLOCK button of each key fob to finalize the programming and confirm system operation.
11. Clear any DTC's and remove the scan tool.
