Corvette V8-6.2L (2008)
Parts Information
Parts required to complete this recall are to be obtained from General Motors Service and Parts Operations (GMSPO). Please refer to your "involved
vehicles listing" before ordering parts. Normal orders should be placed on a DRO = Daily Replenishment Order. In an emergency situation. Parts should
be ordered on a CSO = Customer Special Order.
Service Procedure
Tools Required
J-46079, Tire Pressure Monitor Diagnostic
Remove the front floor console side trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side in SI.
Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in SI.
Remove and replace remote control door lock receiver. Refer to Remote Control Door Lock Receiver Replacement in SI.
REMOTE CONTROL DOOR LOCK RECEIVER PROGRAMMING
The following procedures must be performed in the order listed below:.
Perform the Keyless Entry Transmitter Programming procedure below:
Using the scan tool access the following:
Vehicle Control Systems
Computer/Integrating Systems
Module Setup
Remote Control Door Lock Receiver
Program Key Fobs Choose the following:
Invalidate all Fobs
Press the PROGRAM button on the scan tool. The DIC should display: READY FOR FOB 1.
Place fob # 1 (check the top of the fob to assure its the correct one) in the glove box fob pocket with the buttons facing right.
A beep will occur indicating the fob has been programmed and the DIC will display: READY FOR FOB 2.
Place fob # 2 (check the top of the fob to assure its the correct one) in the glove box fob pocket with the buttons facing right.
A beep will occur indicating the fob has been programmed and the DIC will display: READY FOR FOB 3. Press the lower portion of the start button
(OFF/ACC) to exit the programming mode.
Failure to press the UNLOCK button of each key fob will result in that fob being inoperative. Pressing the UNLOCK button finishes the programming
sequence and is required to ensure transmitter operation.
Press the UNLOCK button of each key fob to finalize the programming and confirm system operation.
Immobilizer System Component Programming
This 10-minute relearn procedure will relearn the fuel enable password between the remote control door lock receiver (RCDLR) and the engine control
module (ECM).