Corvette V8-6.2L (2008)
2. Position the striker to the windshield header (3).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the striker screws. Do NOT tighten.
4. Install the electrical connector to the striker on the left only.
5. Position the folding top panel so that the panel is resting unlatched on the windshield header, with the locating pins in the strikers.
6. Manually latch the folding top. Apply pressure to the locating pin so that the rubber bumper is contacting the striker.
7. Open the folding top.
Tighten the bolts to 8 N.m (71 lb in).
8. Close the folding top while inspecting the alignment of the locating pin to the striker. Close and latch the folding top.
9. Remove the protective covering.
10. Cycle the folding top one complete cycle in both directions.
11. Inspect the folding top for proper operation.
