Corvette V8-6.2L (2008)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Heated Seats Description and Operation (See: Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the appropriate heated seat switch.
2. Ignition OFF, verify that a test lamp illuminates between B+ and the heated seat switch ground circuit terminal 3.
‹› If the test lamp does not illuminate, test the ground circuit for an open/high resistance.
3. Connect the harness connector at the appropriate heated seat switch.
4. Ignition OFF, disconnect the X1 harness connector at the appropriate heated seat module and observe the heated seat switch indicators. Both
indicators should be OFF.
‹› If either of the indicators is illuminated, test the appropriate control circuit for a short to voltage. If the circuit tests normal, replace the
appropriate heated seat switch.
5. Connect a 3-amp fused jumper between B+ and the inoperative heated seat switch indicator control circuit. The heated seat switch indicator should
illuminate.
‹› If the indicator does not illuminate, test the appropriate control circuit for a short to ground or an open/high resistance. If the circuit tests
normal, test or replace the appropriate heated seat switch.
6. If all circuits test normal, replace the inoperative heated seat module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
*
Heated Seat Switch Replacement (See: Seat Heater Switch/Service and Repair)
*
Control Module References (See: Testing and Inspection/Programming and Relearning)for heated seat module replacement, setup, and
programming
Front Heated Seat Malfunction
Front Heated Seat Malfunction
Diagnostic Instructions
*
Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Circuit/System Description
Battery voltage is supplied at all times to the heated seat modules through the DRVR HTD SEAT fuse and the PASS HTD SEAT fuse located in the IP
fuse block. This voltage is used by each module to supply power to the seat cushion and seat back heating elements. Each heated seat module is also
