Corvette V8-6.2L (2008)
Intake Manifold: Service and Repair
Engine Block Valley Cover Replacement
Engine Block Valley Cover Replacement
Removal Procedure
1. Remove the intake manifold. Refer to Intake Manifold Replacement (See: ) .
2. Remove the oil pressure switch. Refer to Engine Oil Pressure Sensor and/or Switch Replacement (See: Engine Lubrication/Oil Pressure
Sensor/Service and Repair) .
3. Remove the engine valley retaining bolts (1).
4. Remove the engine valley cover (2).
5. Remove the engine valley gasket (3).
6. Remove the O-rings (4) from the engine valley cover (2).
Installation Procedure
1. Install the O-rings (4) to the engine valley cover (2).
2. Install the engine valley gasket (3).
3. Install the engine valley cover (2).
4. Install the retaining bolts (1).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Tighten the engine valley retaining bolts.
Tighten the engine valley cover bolts to 25 N.m (18 lb ft).