Corvette V8-6.2L (2008)
1. Install the mode actuator.
Notice: Refer to Fastener Notice .
2. Install the mode actuator mounting screws.
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the mode actuator electrical connector.
4. Install the SIR bracket. Refer to Instrument Panel Inflatable Restraint Module Bracket Replacement (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair) .
5. Recalibrate the actuators. Refer to Actuator Recalibration (See: Testing and Inspection/Programming and Relearning) .
Recirculation Actuator Replacement
Recirculation Actuator Replacement
Removal Procedure
1. Remove the RH lower insulator panel. Refer to Instrument Panel Insulator Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair) .
