Corvette V8-6.2L (2008)
12. Disconnect the front evaporator inlet line from the evaporator rear line assembly.
13. Remove and discard the O-rings.
14. Cap or tape the evaporator rear line assembly.
15. Disconnect the surge tank outlet hose and the inlet heater hose from the underhood junction box retainer clip.
16. Remove the front evaporator inlet line from the vehicle.
Installation Procedure
1. Install the front evaporator inlet line to the vehicle.
2. Connect the surge tank outlet hose and the inlet heater hose to the underhood junction box retainer clip (1).
3. Remove cap or tape from the evaporator rear line assembly.
4. Install new O-rings to the rear evaporator line assembly. Refer to O-Ring Replacement (See: Coupler HVAC/A/C Coupler O-ring/Service and
Repair/O-Ring Replacement) .
5. Connect the front evaporator inlet line to the evaporator rear line assembly.
6. Raise the vehicle.
7. Remove cap or tape from the A/C condenser.
