Corvette V8-6.2L (2008)
3. Install the underhood junction block connector bolts.
Tighten the underhood junction block connector bolts to 7 N.m (62 lb in).
4. Turn the electrical center right side up.
5. Connect the electrical cable retainers at the rear of the junction block.
6. Install the junction block cover.
7. Install the positive battery cable lead to the junction block stud. Install the positive battery cable lead nut.
Tighten the positive battery cable lead nut to 10 N.m (89 lb in).
8. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair)Battery Negative Cable Disconnection and Connection (7.0L) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair) .
