Corvette V8-6.2L (2008)
Radiator Hose: Service and Repair
Radiator Inlet Hose Replacement
Radiator Inlet Hose Replacement
Tools Required
J 38185 Hose Clamp Pliers
Removal Procedure
1. Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716) Cooling System Draining and Filling (Static Fill).
2. Remove the radiator support. Refer to Radiator Support Replacement.
3. Disengage tension on the radiator inlet hose clamp at the radiator using J 38185 .
4. Disconnect the radiator inlet hose from the radiator.
5. Disengage tension on the radiator inlet hose clamp at the water pump using J 38185 .
6. Disconnect the radiator inlet hose from the water pump.
7. Remove the radiator inlet hose from the vehicle.
Installation Procedure
Notice: Make sure the reference marks on the hoses and the radiator are lined up. A twist on the hose would place strain on the radiator fitting
which could cause the fitting to crack or break.
Important: Lubricate the inside diameters of the hose with clean coolant prior to installation.
