Corvette V8-6.2L (2008)
Multiple Junction Connector: All Technical Service Bulletins
Electrical - Service Active handling Message/DTC C0710
Bulletin No.: 06-02-35-002B
Date: October 19, 2007
TECHNICAL
Subject:
Stabilitrak/Active Handling Light On, Service Stabilitrak/Active Handling Message on DIC, DTC C0710 Steering Wheel Position Sensor (SWPS)
Signal Set (Install Clip in SWPS Connector)
Models:
2008 Buick Lucerne
2004-2008 Cadillac XLR
2006-2008 Cadillac DTS
2005-2008 Chevrolet Corvette
with Steering Wheel - Tilt, Telescoping (RPO N37 or N38)
Supercede:
This bulletin is being revised to update the models and provide new correction information. Please discard Corporate Bulletin Number 06-02-35-002A
(Section 02 - Steering).
Condition
Some customers may comment on a Stabilitrak(R) or Active Handling System light being illuminated. Also, this warning light will be accompanied by a
SERVICE STABILITRAK or SERVICE ACTIVE HNDLG message on the DIC. Diagnosis with a scan tool may reveal a DTC C0710.
Cause
The most likely cause of a DTC C0710 on a vehicle equipped with telescoping/tilt steering wheel is high resistance in SWPS connector C202. Fretting
terminal corrosion may be present in the SWPS connector due to the telescoping motion of the steering column. When the steering column is telescoped
in and out, the female terminals within the SWPS connector may move on the male terminals of the SWPS. This movement between the terminals may
cause a high resistance condition in the SWPS connector.
Correction
Remove the drivers side closeout (insulator) panel.
Locate the SWPS connector that connects to the steering angle sensor, located on the lower center of the steering column.
Install the clip (1), P/N 19179794, into the connector. This clip will act as a terminal positive assurance (TPA) and prevent any movement of the
terminals.
Reinstall the closeout panel.
Clear the DTC with a scan tool and road test the vehicle.
