Corvette V8-6.2L (2008)
3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
Important: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
5. Install the camshaft position sensor mounting bolts.
Tighten the camshaft position mounting bolts 25 N.m (18 lb ft).
6. Install the generator assembly. Refer to Generator Bracket Replacement (See: Starting and Charging/Charging System/Alternator/Service and
Repair/Generator Bracket Replacement) .
