Corvette V8-6.2L (2008)
Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals) .
2. Drain the engine of oil.
3. Disconnect the electrical connector (1).
4. Remove the engine oil lever sensor.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the drain plug.
Tighten the drain plug to 25 N.m (18 lb ft).