Corvette V8-6.2L (2008)
Backup Lamp Switch: Service and Repair
Backup Lamp Switch Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals) .
2. Remove the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side (6.2L))Catalytic Converter Replacement - Left Side
(7.0L) () and Catalytic Converter Replacement - Right Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair/Catalytic Converter Replacement - Right Side (6.2L))Catalytic Converter Replacement - Right Side (7.0L) () .
3. Disconnect the backup lamp switch electrical connector.
4. Remove the backup lamp switch.
Installation Procedure
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
1. Install the backup lamp switch.
Tighten the backup lamp switch to 20 N.m (15 lb ft).
2. Connect the backup lamp switch electrical connector.