Corvette V8-6.2L (2008)
2 - Assist Lever
3 - Wiredress Cover
4 - Seal Strain/Relief
5 - Slide Left Hand
6 - Slide Right Hand
7 - Terminal Positive Assurance (TPA)
8 - Terminal Positive Assurance (TPA)
9 - Connector Seal
10 - Connector Housing
11 - Inner Connector
Identifying Connectors
Knowing the connector manufacturer is helpful when trying to locating the correct connector repair procedure. There are many different connector
designs used on GM vehicles and it is sometimes difficult to identify the connector manufacturer. The information in this document should help with the
identification of connector manufactures.
The following connector manufacturers make most of the connectors found in GM vehicles:
*
AFL/EPC (Alcoa Fujikura Ltd./Engineered Plastics Components)
*
Bosch
*
Delphi
*
FCI (Framatome Connectors International)
*
JAE (Japan Aviation Electronics)
*
JST (Japan Solderless Terminals)
*
Kostel
*
Molex
*
Sumitomo
*
Tyco/AMP
*
Yazaki
Identifying the manufacturer of a connector is often difficult. When trying to determine the manufacturer of a connector, look for specific identifying
marks that are unique to that connector supplier. Most of these identify marks are hard to find or see. Check the connector carefully and refer to the
information below for pictures and descriptions of connector identification markings.
*
Most of AFLs connectors have EPC on their connector body. Some of the smaller connectors will not have any markings on them.
