Corvette V8-6.2L (2008)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley Replacement
Power Steering Pump Pulley Replacement
Special Tools
*
J 25033-C Power Steering Pump Pulley Installer
*
J 25034-C Power Steering Pump Pulley Remover
Removal Procedure
1. Remove the brake pressure modulator valve (BPMV). Refer to Brake Pressure Modulator Valve Replacement (See: Brakes and Traction
Control/Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure Modulator
Valve Replacement) .
2. Remove the BPMV bracket. Refer to Brake Pressure Modulator Valve Bracket Replacement (See: Brakes and Traction Control/Antilock Brakes /
Traction Control Systems/Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Brake Pressure Modulator Valve Bracket
Replacement) .
3. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory (See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts,
Brackets and Accessories/Drive Belt/Service and Repair/Drive Belt Replacement - Accessory) .
4. Install the J 25034-C on the power steering pump pulley and remove the pulley.
Installation Procedure
1. Using J 25033-C , install the power steering pump pulley onto the power steering pump.
Important: The pulley must be installed onto pump shaft so that the pulley hub is flush to within 0.25 mm (0.010 in) with the pump shaft.
