Corvette V8-6.2L (2008)
Steering Gear: Service and Repair
Rack and Pinion Inner Tie Rod Replacement
Rack and Pinion Inner Tie Rod Replacement
Tools Required
J 34028 Inner Tie Rod Wrench
Removal Procedure
1. Raise the vehicle. Support the vehicle with suitable safety stands.
2. Remove the tire and wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and
Repair) .
Important: After removing the boot, inspect the inner tie rod for evidence of corrosion or contamination. If none is evident, continue
with the repair. If corrosion or contamination is evident, replace the steering gear.
3. Remove the rack and pinion boot. Refer to Rack and Pinion Boot Replacement (See: Tie Rod/Tie Rod Boot/Service and Repair) .
Notice: Do not change the rack bearing preload adjustment before removing the inner tie rod from the steering rack. This could cause damage to
the pinion or the steering rack or both.
4. Remove the shock dampener (2) from the inner tie rod (5).
5. Slide the shock dampener (2) back onto the rack (1).
Important: Do not hold the steering rack while removing the inner tie rod if the preload adjustment has not been changed.
6. Remove the inner tie rod (5) from the rack assembly (1) as follows:
*
Place a wrench on the flats of the inner tie rod housing (4).
*
Rotate the inner tie rod housing (4) counterclockwise until the inner tie rod (5) separates from the rack.