Corvette V8-6.2L (2008)
5. Using a back-up wrench to prevent the link stud from rotating, install the stabilizer shaft link to the control arm.
Tighten the stabilizer shaft link nut to 72 N.m (53 lb ft).
6. Install the shock absorber to the lower control arm. Refer to Shock Absorber Replacement (See: Suspension Strut / Shock Absorber/Service and
Repair/Rear Suspension Shock Absorber) .
7. Remove the jackstand.
8. Release and remove J 33432-A from the transverse spring.
9. Connect the suspension position sensor link, if equipped to the control arm link stud.
