Corvette V8-6.2L (2008)
Shift Cable: Service and Repair
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Service Intervals) .
2. Shift the floor shift control to NEUTRAL.
If replacing a damaged cable, be sure that BOTH the floor shift control and the transmission are in NEUTRAL.
3. Remove the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side (6.2L))Catalytic Converter Replacement - Left Side
(7.0L) () and Catalytic Converter Replacement - Right Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair/Catalytic Converter Replacement - Right Side (6.2L))Catalytic Converter Replacement - Right Side (7.0L) () .
4. Remove the driveline tunnel closeout panel.
Important: Use care to not suddenly jerk the shift control cable during disassembly, the shift control cable rod end guide tubes are
EXTREMELY INFLEXIBLE and capable of only a SLIGHT bend.
5. Using a large flat bladed screwdriver, CAREFULLY release the shift control cable end clip (1) from the floor shift control arm stud.
6. Remove the shift control cable (2) from the driveline tunnel bracket.
1. Using a flat bladed screwdriver, pry the cable retaining staple clip from the cable.
2. Depress the cable retaining tabs.
3. While depressing the tabs, push the tabs through the hole in the driveline tunnel bracket.
4. Slide the cable out of the bracket slot.
