Corvette V8-6.2L (2008)
3. SLOWLY raise the rear suspension crossmember (still firmly attached to a transmission jack), to the vehicle frame rails.
Guide the transaxle mount studs into the slots in the rear crossmember.
4. Using ONLY HAND TOOLS, install NEW rear suspension crossmember mounting nuts.
Tighten the rear suspension crossmember mounting nuts to 110 N.m (81 lb ft).
5. Remove the transmission jack from the rear suspension crossmember.
6. Release the J 42055 from the transmission, then remove the J 42055 and transmission jack.
7. Install the 4 transaxle mount to rear suspension crossmember nuts.
Tighten the transaxle mount to rear suspension crossmember nuts to 50 N.m (37 lb ft).
8. Install the rear shock absorber lower mounting bolts.
Tighten the rear shock absorber lower mounting bolts to 220 N.m (162 lb ft).
9. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and
Repair) .
10. Lower the vehicle.
11. Connect the negative battery cable.
Tighten the negative battery cable bolt to 15 N.m (11 lb ft).
12. Program the transmitters. Refer to Transmitter Programming (N. America and Japan, except Canada) (See: Testing and Inspection/Programming
and Relearning)Transmitter Programming (Canada and Europe) (See: Testing and Inspection/Programming and Relearning) .
