Corvette V8-6.2L (2008)
Important: Friction discs and separator plates develop specific wear patterns and are a matched set. During disc and plate installation,
the components must be installed in the specific order in which they were removed.
10. Install the left clutch pack to the left case.
*
Install the separator plates (1).
*
Install the friction discs (2).
*
Install the bellville washer (3).
11. Install the left output shaft and gear to the left case.
12. Assemble the case halves.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
13. Install the case bolts.
Tighten the bolts to 55 N.m (41 lb ft).
