Corvette V8-6.2L (2008)
7. Inspect the propeller shaft pins for proper installation. The pin should extend beyond the flange 30 mm (1.18 in).
8. Measure the propeller shaft runout.
1. Mount the propeller shaft in wooden V-blocks or between centers on a fixture.
2. Check the runout of the propeller shaft in multiple locations, including the barrel ends, using the J 7872 .
3. If propeller shaft runout exceeds 0.3 mm (0.118 in), the propeller shaft is bent and should be replaced.
9. Inspect the snubber - manual transmission - for wear or a flat spot on the outer edge.
10. Check the runout of the snubber.
If the runout of the outer edge of the snubber exceeds 2 mm (0.79 in), replace the propeller shaft.
11. Inspect the bearing housing hub for the following conditions:
*
Damaged bolt hole threads (1)
*
Damaged snap ring grooves (2)
*
Worn or damaged splines (3)
*
Worn or damaged bushings
Bushings that have been removed from the hub will be damaged and should not be reused. Install NEW bushings during assembly.
