Corvette V8-6.2L (2008)
Flex Plate: Service and Repair
Engine Flywheel Replacement
Engine Flywheel Replacement
Removal Procedure
Notice: Failure to follow the proper removal and installation procedures may result in damage to the engine crankshaft thrust bearing.
Notice: When tilting down the rear of the driveline, observe the clearance between the rear of the engine and the composite dash panel. Do not allow the
engine to rest unsupported against the composite dash panel, or vehicle damage may result.
Notice: When lowering and removing the rear of the driveline, observe the clearance between the rear of the transaxle assembly and the underbody to
prevent damage.
Important:
*
For manual transmission applications, note the position and direction of the engine flywheel before removal. The flywheel does not use a
locating pin for alignment. Mark or scribe the end of the crankshaft and the flywheel before component removal. The engine flywheel
must be reinstalled to the original position and direction. The engine flywheel will not initially seat against the crankshaft flange, but will
be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a 3 stage tightening process.
*
DO NOT remove the prop shaft hub or flex plate from the automatic transmission engine flywheel. The flywheel, prop shaft hub, and flex
plate are balanced as an assembly. If service is required, the entire flywheel assembly should be replaced.
1. Remove the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side (6.2L))Catalytic Converter Replacement - Left Side
(7.0L) () and Catalytic Converter Replacement - Right Side (6.0L) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair/Catalytic Converter Replacement - Right Side (6.2L))Catalytic Converter Replacement - Right Side (7.0L) () .
2. Remove the driveline support, if equipped with a automatic transmission. Refer to Driveline Support Assembly Replacement (See:
Drive/Propeller Shafts, Bearings and Joints/Torque Tube/Service and Repair/Removal and Replacement/Driveline Support Assembly
Replacement) .
3. Remove the clutch assembly, if equipped with a manual transmission. Refer to Clutch Assembly Replacement (See: Clutch/Service and Repair) .
4. Mark or scribe the end of the crankshaft and the manual transmission flywheel. Refer to Engine Balancing (See: Engine, Cooling and
Exhaust/Engine/Service and Repair/Procedures) .
5. If equipped with an automatic transmission, remove the engine flywheel bolts.
