Corvette V8-6.2L (2008)
Back Window Glass: All Technical Service Bulletins
Body - Rear Glass Inner Moulding Loose
TECHNICAL
Bulletin No.: 09-08-110-016
Date: June 26, 2009
Subject: Rear Glass Inner Molding Loose (Apply Adhesive)
Models:
2007-2009 Corvette Coupe, Z06 and ZR1
Condition
Some customers may comment that the inner rear window glass molding is loose.
The molding may be loose or hanging in the top center area of the window where the two sides of the molding meet.
Cause
This condition may be caused by a lack of tension in the molding assembly. When the sun load increases the vehicle cabin temperature, the molding may
loosen from the edge of the rear compartment lift window panel (liftgate) and sag.
Correction
Important
Do not replace the rear window glass molding to correct this condition.
1. Locate the center joint of the inner rear glass molding and apply a section of masking tape to the inner liftgate. Mark the center joint location on
the masking tape.
2. Pull the molding loose from the inner liftgate on both sides of the center joint.
3. Clean the inner liftgate and the molding with a general purpose adhesive cleaner in the area to be bonded.
