Corvette V8-6.2L (2008)
1. Apply a 100 mm (4 in) long bead of sealant GM P/N 12345097, or equivalent, across the seam where the roof and windshield header meet.
2. Install the reward end of the side reveal molding over the lock pillar upper molding.
3. Align the applique to the slot (2) in the filler panel (1).
Notice: Refer to Fastener Notice .
4. Loosely install the side reveal molding screws.
5. Tighten the screws in sequence (1-6), starting in the center as illustrated.
Tighten the side reveal molding screws to 2.5 N.m (22 lb in).
6. Apply sealant, install the weatherstrip retainer, the blow out clip, and the weatherstrip. Refer to Weatherstrip Side Retainer Replacement (Hardtop)
(See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Weatherstrip/Service and Repair)Weatherstrip Side Retainer
Replacement (Coupe and Convertible) (See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Weatherstrip/Service and
Repair) .
