Corvette V8-6.2L SC (2009)
5. Install the EN-48853 onto the crankshaft.
6. Tighten the crankshaft balancer bolt by hand until snug. Do not overtighten.
7. Install the front cover.
Note: Align the tapered legs of the tool with the machined alignment surfaces on the front cover.
8. Remove the tool.
9. Inspect the CMP sensor O-ring seal (704) for cuts or damage. If the seal is not cut or damaged, it may be used again.
10. Lubricate the O-ring seal with clean engine oil.
11. Install the O-ring seal onto the sensor (703).
12. Install the sensor to the cover.
13. Install the CMP sensor and bolt (705) and tighten to 12 Nm (106 lb in).
14. Install the new crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Replacement (See: Seals and Gaskets/Front Crankshaft Seal/Service
and Repair).
