Corvette V8-6.2L SC (2009)
Note: It may be necessary to use a long pair of 90 degree needle nose pliers to lift the plunger and remove the plug assembly.
3. Unlock the fill tube plug by lifting the plunger. Once the plunger is lifted, remove the entire plug assembly.
4. Determine the approximate amount of fluid needed to fill the transmission, based on the repair performed. Refer to Fluid Capacity Specifications
(See: Specifications/Capacity Specifications). To avoid an under-fill condition, slightly overfill the transmission, and then allow the extra fluid to
drain during the fluid checking procedure.
Note: The J 45096 - flush and flow test tool is being utilized as a convenient method to pump the fluid into the bottom pan. A suitable hand pump
may also be used instead. When using the J 45096 - flush and flow test tool , monitor the display panel to determine the amount of fluid being
pumped from the tool supply tank into the transmission.
5. Using the J 45096-40 - transflow oil fill adapter (1) and the J 45096 - flush and flow test tool (2), or a suitable hand pump, add transmission fluid
through the fill tube plug opening. Refer to Transmission Fluid Cooler Flushing and Flow Test (See: Testing and Inspection/Transmission Fluid
Cooler Flushing and Flow Test) for complete J 45096 - flush and flow
test tool operating instructions. Use the FLOW position on the main function switch to pump the fluid.
6. Check the fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General Diagnostics/Transmission
