Corvette V8-7.0L (2007)
Power Seat Motor: Service and Repair
Front Seat Adjuster Motor Replacement
Removal Procedure
The power seat motors are only available as an assembly with the adjusters. To replace the assembly follow the procedure to replace the adjuster. Refer
to Front Seat Adjuster Replacement.
1. Remove the seat.
2. Remove or reposition the lumbar pump, if equipped.
Remove the tie straps attaching the pump to the torque tube and reposition the pump.
3. Slide the front motor bracket to one side.
4. Remove that drive cable.
5. Slide the bracket off that adjuster transmission.
6. Slide the bracket in the opposite direction and remove the drive cable and the bracket from that adjuster transmission.
7. Position the bracket outward.
8. Disconnect the motor electrical harness connector.
9. Remove the front motor.
10. Mark the location and position of the rear motors to aid in installation.
11. Remove the motors with harness.
Installation Procedure
