Corvette V8-7.0L (2007)
7. Remove the brake pipes from the BPMV (1, 2) to the rear brake calipers, noting the location.
8. Disconnect the electrical connector from the brake fluid pressure sensor (2).
9. Remove the two insulator nuts (1).
10. Remove the EBCM/BPMV from the vehicle as one unit.
11. Remove the insulator mounting bolt from the EBCM.
12. Remove the four EBCM to BPMV bolts.
13. Separate the EBCM from the BPMV by gently pulling apart until separated.
14. Carefully remove the seal.
The seal may be reused if it is not cut or damaged.
Installation Procedure
Important: When installing a new BPMV, do NOT remove the shipping plugs from the outlets until after installation into the vehicle.
