Corvette V8-7.0L (2007)
10. Install the brake pipes from the front brake calipers (1, 2) to the BPMV in the same location as removed.
Tighten the brake pipe fittings to 16 N.m (12 lb ft).
11. Install the brake pipes from the master cylinder (1, 2) to the BPMV in the same location as removed.
Tighten the brake pipe fittings to 16 N.m (12 lb ft).
12. Connect the BPMV pump motor ground.
13. Connect the EBCM harness connector.
Important: Both sides of the EBCM harness connector must be engaged with lever before closing.
14. Install the power steering fluid reservoir and bracket.
15. Fill and bleed the hydraulic brake system.
16. Perform the Automated Bleed Procedure. Refer to Antilock Brake System Automated Bleed Procedure.
17. Perform the Symptoms - Antilock Brake System. See: Testing and Inspection/Symptom Related Diagnostic Procedures/Symptoms - Antilock
Brake System
