Corvette V8-7.0L (2007)
Important:
*
Ensure the pushrods seat properly to the ends of the rocker arms.
*
DO NOT tighten the rocker arm bolts at this time.
Install the rocker arms (213) and bolts (214).
Note the locations of the intake (1) and exhaust (2) valve rocker arms. The intake rocker arms (1) have an offset design.
3. Rotate the crankshaft until number one piston is at top dead center of compression stroke.
The engine firing order is 1, 8, 7, 2, 6, 5, 4, 3.
Cylinders 1, 3, 5 and 7 are left bank.
Cylinders 2, 4, 6, and 8 are right bank.
Notice: Refer to Fastener Notice.
4. With the engine in the number one firing position, tighten the following valve rocker arm bolts:
*
Tighten exhaust valve rocker arm bolts 1, 2, 7, and 8 to 30 N.m (22 lb ft).
*
Tighten intake valve rocker arm bolts 1, 3, 4, and 5 to 30 N.m (22 lb ft).
5. Rotate the crankshaft 360 degrees.
6. Tighten the following valve rocker arm bolts:
*
Tighten exhaust valve rocker arm bolts 3, 4, 5, and 6 to 30 N.m (22 lb ft).
*
Tighten intake valve rocker arm bolts 2, 6, 7, and 8 to 30 N.m (22 lb ft).
7. Install the valve rocker arm covers.
